Registration Memory – Saving and Recalling Custom Panel Setups –
6
76 PSR-A2000 Owner’s Manual
4 Press one of the REGISTRATION MEMORY [1] – [8] buttons to
which you wish to memorize the panel setup.
The memorized button becomes red, which indicates the number button
contains data and its number is selected.
5 Register various panel setups to other buttons by repeating
steps 1 – 4.
The registered panel setups can be recalled by simply pressing the desired
number button.
You can save all the eight registered panel setups as a single Registration Memory
Bank file.
1 Press the REGIST BANK [+] and [-] buttons simultaneously to
call up the Registration Bank Selection Display.
2 Press the [6▼] (SAVE) button to save the Bank file.
For instructions on saving, refer to page 66.
If you select the button whose
lamp is lit in red or green here,
the panel setup previously
memorized to the button will be
erased and replaced by the new
settings.
About the lamp status
• Red: Data registered and currently selected
• Green: Data registered but not currently selected
• Off: No data registered
The panel setups registered in the
numbered buttons are preserved even
when you turn off the power. If you
want to delete all the eight current
panel setups, turn the [ ]
(Standby/On) switch on while holding
the B5 key (right-most B key on the
keyboard).
Saving the Registration Memory as a Bank file
Bank 01
Bank 02
Bank 03
Bank 04
2
To Next Page
Loading...
Need help?
General
