Connections – Using Your Instrument with Other Devices –
10
96 PSR-A2000 Owner’s Manual
• When using a USB cable to connect
the instrument to your computer,
make the connection directly with-
out passing through a USB hub.
• For information on setting up your
sequence software, refer to the
owner’s manual of the relevant soft-
ware.
Precautions when using the [USB TO HOST] terminal
When connecting the computer to the [USB TO HOST] terminal, make sure
to observe the following points. Failing to do so risks freezing the computer
and corrupting or losing the data. If the computer or the instrument freezes,
restart the application software or the computer OS, or turn the power to the
instrument off then on again.
NOTICE
• Use an AB type USB cable of less than 3 meters. USB 3.0 cables cannot be used.
• Before connecting the computer to the [USB TO HOST] terminal, exit from any power-saving
mode of the computer (such as suspend, sleep, standby).
• Before turning on the power to the instrument, connect the computer to the [USB TO HOST] ter-
minal.
• Execute the following before turning the power to the instrument on/off or plugging/unplugging
the USB cable to/from the [USB TO HOST] terminal.
• Quit any open application software on the computer.
• Make sure that data is not being transmitted from the instrument. (Data is transmitted only by
playing notes on the keyboard or playing back a song.)
• While the computer is connected to the instrument, you should wait for six seconds or more
between these operations: (1) when turning the power of the instrument off then on again, or (2)
when alternately connecting/disconnecting the USB cable.
To Next Page
Loading...
Need help?
General
