SETUP
Setting sound program parameters (Sound Program menu)
En 113
Front Presence R Level
Adjusts the volume of the front presence R channel. J1
Parameters usable in surround decoder
Decode Type
Selects a surround decoder.
Dolby PLIIx Music and Dolby PLII Music only
Panorama
Adjusts the soundscape of the front sound field. Sends front left/
right channels sounds to the surround speakers as well as the front
speakers for a wraparound effect.
Center Width
Spreads the center channel sound to the front left and right
speakers to suit your needs or preferences. Set this parameter to 0
for outputting the center sound from the center speaker only, or to 7
for outputting it from the front left/right speaker only.
Dimension
Adjusts the difference in level between the front sound field and
the surround sound field. You can adjust the difference in level
created by the software being played back to obtain the preferred
sound balance.
The surround sound gets stronger as you make the value more
negative, and the front sound gets stronger as you make the value
more positive.
When Neo:6 Music is selected
Center Image
Adjusts the front left and right channel output relative to the center
channel to make the center channel more or less dominant as
necessary.
Adjustable range 0 to 100%
Default setting 33%
Pro Logic Reproduces sound using the Dolby Pro Logic
decoder. This is suitable for all kinds of audio sources.
PLIIx Movie /
PLII Movie
Reproduces sound using the Dolby Pro Logic IIx (or
Dolby Pro Logic II) decoder. This is suitable for
movies. J2
PLIIx Music /
PLII Music
Reproduces sound using the Dolby Pro Logic IIx (or
Dolby Pro Logic II) decoder. This is suitable for
music. J2
PLIIx Game /
PLII Game
Reproduces sound using the Dolby Pro Logic IIx (or
Dolby Pro Logic II) decoder. This is suitable for
games. J2
Neo:6 Cinema Reproduces sound using the DTS Neo:6 decoder. This
is suitable for movies.
Neo:6 Music Reproduces sound using the DTS Neo:6 decoder. This
is suitable for music.
Off (Default) Disables the effect.
On Enables the effect.
Adjustable range 0 to 7
Default setting 3
Adjustable range -3 to +3
Default setting 0
Adjustable range 0.0 to 1.0
Default setting 0.3
J
1 : Not displayed when speakers are set to be inactive.
J
2 : You cannot select the Dolby Pro Logic IIx decoder in the following conditions:
• When “Surround Back” is set to “None” (☞
p. 117).
• When headphones are connected.
To Next Page
Loading...
Need help?
General