SETUP
Setting various functions (Setup menu)
En 131
Target Source
Specify the output level of electronic signal transmitted each time
input is switched.
Manual
Manually switch the output level for electronic signal transmission.
This setting can also be used to confirm proper function of the
external component connected via the TRIGGER OUT 1 or 2 jack.
■
Prohibiting setting changes
Memory Guard
Prohibits setting changes to prevent careless changes being made
to the settings on Setup menu.
Language
Select the language used for display of menus and messages. J3
Choices: English (English), (Japanese), (French),
(German), (Spanish),
(Russian)
Low J1 Terminates electronic signal transmission when the
input source specified with this option is selected.
High (Default) J2 Electronic signal is transmitted when the input source
specified with this option is selected.
This setting is available only when “Trigger Mode” is set to
“Source.”
Low J1 Stops the electronic signal transmission.
High (Default) J2 Transmits the electronic signal.
This setting is available only when “Trigger Mode” is set to
“Manual.”
Off (Default) Settings are not protected.
On Prohibits changes to the settings on Setup menu until
it is returned to “Off.”
While set to “On,” the unit displays “Memory
Guard!” when an attempt is made to change the
settings.
For details on selecting a language, refer to “Language
selection” (☞
p. 2).
J
1 : This unit outputs 0 V when selecting “Low.”
J
2 : This unit outputs 12 V when selecting “High.”
J
3 : Content window information is displayed in the language in which that
information was released.
To Next Page
Loading...
Need help?
General