SETUP
En 144
The Advanced Setup menu can be used for unit initialization and other useful extended functions. The Advanced Setup menu can be operated as follows.
Displaying/Setting the Advanced Setup
menu
1
Switch this unit to the standby mode.
2
Press MAIN ZONE A while pressing and holding
STRAIGHT on the front panel.
Release STRAIGHT when “ADVANCED SETUP” is displayed
on the front panel display.
After a few seconds, the top menu items are displayed.
3
Press PROGRAM l / h repeatedly to select the item
to be set from the following items.
In the Advanced Setup menu, you can set the following settings.
4
Press STRAIGHT repeatedly to select the value you
want to change.
5
Switch this unit to the standby mode, and then
switch it on again.
The settings become effective and the unit is powered on.
Setting the impedance of speakers
Changes the unit settings depending on the impedance of the
speakers connected. J1
Extended functionality that can be configured as needed (Advanced Setup menu)
PROGRAM l / h
MAIN ZONE A STRAIGHT
SPEAKER IMP. Sets the impedance of speakers.
REMOTE SENSOR Activate or deactivate the signal-receiving capability
of the remote control sensor.
REMOTE CON AMP Changes the remote control ID of a receiver.
SIRIUS PIN Resets the parental lock code for the SIRIUS Satellite
Radio tuner.
TV FORMAT Specifies the TV’s color encoding format.
MONITOR CHECK Removes the up-scaling limitation on HDMI video
output.
RECOV./BACKUP Save and restore the settings of this unit.
INITIALIZE Initializes various settings for this unit.
FIRM UPDATE Update the firmware of this unit.
VERSION Check the version of firmware currently installed on
this unit.
Select the impedance when 6 Ω speakers are
connected.
(Default) Select the impedance when speakers above 8 Ω are
connected.
SPEAKERIMP.
8MIN
6MIN
8MIN
J
1 : For detailed procedures of speaker impedance settings, refer to “Changing
speaker impedance” (☞
p. 21).
To Next Page
Loading...
Need help?
General