Yamaha RX-A3000 User Manual

CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
En 50
When “E-7” or “E-8” is displayed:
1
Press iENTER.
2
Check that the environment is suitable for
accurate measurement.
3
Press iCursor E to select “RETRY.”
4
Press iENTER to use YPAO again.
When “E-5” or “E-9” is displayed:
1
Press iENTER.
2
Check that the environment is suitable for
accurate measurement.
3
Press iCursor D / E to select a option.
PROCEED:
When “E-5” is displayed, measurement can proceed.
However, the measurement in noisy environment may
reduce the accuracy.
When “E-9” is displayed, resume the aborted step.
RETRY:
Restart measurement from the beginning.
4
Press iENTER to execute the selected
option.
When “E-10” is displayed:
1
Press iENTER.
2
Press iCursor E to select “EXIT.”
3
Press iENTER to terminate YPAO, and
switch the unit to standby mode.
4
Turn on the unit and use YPAO again.
■ When a warning message is
displayed after measurement
See “Warning messages” (☞p. 51) for instructions on
resolving the problem. The speaker causing the problem
can be confirmed from the TV screen display.
To exit YPAO with some options
1
Use iCursor B / C to select “Save/Exit”
and press iENTER.
2
Use iCursor D / E to select one of the
following options and press iENTER.
SAVE:
Exits YPAO applying the results of measurement.
CANCEL:
Returns to the previous screen (warning message
screen).
EXIT:
Exits YPAO without saving the results.
ENTER
ENTER
SOU
R
C
E
R
ECEIVE
R
AV
AU
DI
O
4
3
1
2
7
5
6
V
-A
UX
4
3
1
2
US
B
MU
LTI
N
ET
P
H
O
N
O
TUNER
D
OC
K
S
IRI
US
[
A
]
i
NOTE
Although the results of acoustics measurement can be
applied when a warning message is displayed, optimal
sound will not be achieved. Resolving the problem
and using YPAO to measure acoustics again is
recommended.

Yamaha RX-A3000 Specifications

General

Brand	Yamaha
Model	RX-A3000
Category	Receiver
Language	English