Yamaha WR250F 2021 - Page 40

MULTI-FUNCTION DISPLAY
1-28
Resetting is possible while timer measurement
is made:
• Reset average speed (AVS).
• Reset average speed (AVS)/tripmeter A.
Resetting is possible while timer measurement
is not made:
• Reset average speed (AVS)/tripmeter A/timer.
Resetting average speed (AVS)
1. Check that the timer is in operation. If the tim-
er is not in operation, start the timer by push-
ing the “SLCT1” button and “SLCT2” button
at the same time.
2. Reset the average speed display by pushing
the “RST” button.
TIP
If reset, “ ” and the average speed display
will go on flashing for four seconds.
Resetting average speed (AVS) and tripme-
ter A (TRIP A)
1. Check that the timer is in operation. If the tim-
er is not in operation, start the timer by push-
ing the “SLCT1” button and “SLCT2” button
at the same time.
2. Reset tripmeter A (TRIP A) display and the
average speed display by pushing the “RST”
button for 2 seconds or more.
TIP
If reset, “ ”, “ ”, the travel distance display,
and average speed display will go on flashing for
four seconds.
Resetting average speed (AVS), tripmeter A
(TRIP A) and timer
1. Check that the timer is not in operation. If the
timer is in operation, stop it by pushing the
“SLCT1” button and “SLCT2” button at the
same time.
2. Reset all measured data by pushing the
“RST” button for 2 seconds or more.
TIP
• Resetting will reset the timer display, travel dis-
tance display, and average speed display and
put measurement on standby.
• Auto start attempt will put measurement on
standby as such. Likewise, manual start at-
tempt will put measurement on standby as
such.
Correcting tripmeter A (TRIP A)
1. Change the travel distance display by push-
ing the “SLCT1” button (plus) or “SLCT2” but-
ton (minus). A long push on the button will
fast-forward the change.
TIP
• Change can be made any time while timer
measurement is or is not being made.
• Change in the travel distance display will be
accompanied by the change in the average
speed display.