7.5 Communication Options
Table 7.8 gives detailed information about the available option units that allow Yaskawa
drives to connect to various communications networks. A host controller can control and
monitor the drive, read and change parameters by using a communication option. Refer to
Table 7.8 to determine which option unit may
be necessary for a given environment. Contact
Yaskawa or your Yaskawa agent to order option units.
• Option Unit Selection: Refer to Yaskawa catalog for more details on option unit selection
and part numbers.
• Option Unit Installation: Refer to option unit manual for option unit installation
instructions.
Table 7.8 Available Option Units
Option Unit Model Function
Interface for Copy Unit/PC
Communication
SI-232/JC Allows the drive to connect to an external device.
Interface for Remote Operator SI-232/J Allows the drive to connect to an external device.
Interface for MEMOBUS/
Modbus Communication
SI-485/J
Allows the drive to connect to a network using MEMOBUS/
Modbus RTU protocol.
Potentiometer Option Unit AI-V3/J Allows easy set-up of output frequency.
USB Copy Unit JVOP-181
Allows the user to read, write, copy, and verify parameter settings.
Connects to PC using a USB connector.
For use with the RS-232C
detachable interface option.
LED Operator JVOP-182
Allows the user to read, write, copy, and verify parameter settings.
Can be placed on the outside of an enclosure panel so the panel
door does not have to be opened to access the drive.
7.5 Communication Options
YASKAWA ELECTRIC TOEP C710606 25B YASKAWA AC Drive J1000 Installation & Start-Up Manual
185
7
Peripheral Devices &
Options
2/6/2008-14:44
To Next Page
Loading...
Need help?
General
