Drive Model
CIMR-Jo
Class T Fuses
Class RK5 Fuses
Model
Fuse Ampere
Rating
BA0010 A6T40 40 Contact Yaskawa
200 V Class Three-Phase Drives
2A0001 A6T10 10 Contact Yaskawa
2A0002 A6T10 10 Contact Yaskawa
2A0004 A6T15 15 Contact Yaskawa
2A0006 A6T20 20 Contact Yaskawa
2A0008 A6T25 25 Contact Yaskawa
2A0010 A6T25 25 Contact Yaskawa
2A0012 A6T30 30 Contact Yaskawa
2A0018 A6T40 40 Contact Yaskawa
2A0020 A6T40 40 Contact Yaskawa
400 V Class Three-Phase Drives
4A0001 A6T10 10 Contact Yaskawa
4A0002 A6T10 10 Contact Yaskawa
4A0004 A6T20 20 Contact Yaskawa
4A0005 A6T25 25 Contact Yaskawa
4A0007 A6T25 25 Contact Yaskawa
4A0009 A6T25 25 Contact Yaskawa
4A0011 A6T30 30 Contact Yaskawa
n
Grounding
The drive is designed to be used in T-N (grounded neutral point) networks. If installing the
drive in other types of grounded systems, contact your dealer or Yaskawa for instructions.
u
EMC Guidelines Compliance
This drive is tested according to IEC61800-3:2004 and it complies with the EMC guidelines.
n
EMC Filter Installation
The following conditions must be met to ensure continued compliance with guidelines. Refer
to EMC Filters on page 233 for EMC filter selection.
Installation Method
Verify the following installation conditions to ensure that other devices and machinery used
in combination with this drive also comply with EMC guidelines.
1.
Install an EMC noise filter to the input side specified byYaskawa for compliance with
European standards.
2.
Place the drive and EMC noise filter in the same enclosure.
C.2 European Standards
230
YASKAWA ELECTRIC TOEP C710606 25B YASKAWA AC Drive J1000 Installation & Start-Up Manual
2/6/2008-14:44
To Next Page
Loading...
Need help?
General
