Startup Procedure and Test Run
4
4.4 Start-up Procedures
YASKAWA SIEPC71061737B GA800 Drive Technical Reference 147
Figure 4.10 PM Motor Auto-Tuning and Test Run Procedure
*1 For Yaskawa PM motors (SMRA-series, SSR1-series, or SST4-series), set E5-01 (Motor Code). For PM motors from a different
manufacturer, set E5-01 = FFFF.
*2 Be sure to release the holding brake before doing Inertia Tuning.
*3 In ASR Tuning, the drive will automatically tune Feed Forward control and KEB Ride-Thru 2 parameters.
To Next Page
Loading...
