4.5 Items to Check before Starting Up the Drive
150 YASKAWA SIEPC71061737B GA800 Drive Technical Reference
Note:
Make sure that you use a keypad with FLASH number 1004 or later. Keypads with FLASH numbers 1003 and earlier will not show
characters correctly.
◆ Make the Initial Settings
The keypad will show the Initial Setup screen when energizing the drive for the first time. Users can set the date and
time or the language to show on the keypad. The Setup Wizard prepares the drive for operation, from setting the basic
parameters to performing Auto-Tuning. Refer to Set Parameters Using the Setup Wizard on page 179 for more
information.
Note:
If the keypad does not show the Initial Setup screen, [Initial Setup] from the Main Menu to show the Initial Setup screen.
1. Make the initial settings for each item.
A - Language Selection
B - Set Date/Time
C - Setup Wizard
D - Show Initial Setup Screen
Note:
If you select [Yes] from the [Show Initial Setup Screen] setting, the keypad will show the Initial Setup screen each time the drive is
energized.
If you select [NO], the keypad will not show the Initial Setup screen each time the drive is energized, starting with the next time.
2. Push (Home).
The display shows the HOME screen.
To Next Page
Loading...
