YASKAWA GA800 Series - Disable the Initial Setup Screen

Startup Procedure and Test Run
4
4.6 Keypad Operation
YASKAWA SIEPC71061737B GA800 Drive Technical Reference 181
9. Push or to select [Yes], then push .
The Setup Wizard procedure is complete.
◆ Disable the Initial Setup Screen
Do the steps in this procedure to not show the initial start-up screen when the drive is energized.
1. Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for , push (Back), and then push to show [Home].
2. Push (Menu).
3. Push / to select [Initial Setup], then push .
4. Push / to select [Show Initial Setup Screen], then push .
5. Push / to select [No], then push .
• [No]: The keypad will not show the Initial Setup Screen when the drive is energized.
• [Yes]: The keypad will show the Initial Setup Screen when the drive is energized.