YASKAWA GA800 Series - Page 180

4.6 Keypad Operation
180 YASKAWA SIEPC71061737B GA800 Drive Technical Reference
4. Push or to select [Setup Wizard], then push .
5. Push or to select [Yes], then push .
Note:
This operation will initialize all parameters.
6. Push or to select the item to set, then push .
7. For the next steps, follow the instructions shown on the keypad until the “Parameter Change Confirmation
Screen” is shown.
8. In the parameter change confirmation screen, push or to examine the changed parameter, then
select [Apply of each parameter] at the bottom of the screen and push .
Note:
To change a parameter again, push or to select the parameter to change, then push to show the parameter setting
screen.