4.6 Keypad Operation
152 YASKAWA SIEPC71061737B GA800 Drive Technical Reference
2. Push or to select the digit, then push or to change the value.
3. Push to keep the changes.
Note:
The HOME screen must show U1-01 [Frequency Reference] or you must set the keypad as the Run command source (REMOTE) to use this
function.
■ Show the Main Menu
Push to show the main menu. Push (HOME) to go back to the HOME screen.
◆ Showing the Monitor
This section shows how to show the standard monitors (Ux-xx).
1. Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for , push (Back), and then push to show [Home].
2. Push (Menu).
3. Push or to select [Monitors], then push .
4. Push or to select [Standard Monitor], then push .
To Next Page
Loading...
