8.5 Replace the Drive
422 YASKAWA SIEPC71061737B GA800 Drive Technical Reference
2. Tighten the M3 screws to a tightening torque of 0.5 N∙m to 0.6 N∙m (4.4 lb.∙in. to 5.3 lb.∙in.).
Figure 8.87 Safety the Terminal Block
3. Install the front cover and the keypad to their initial positions.
4. Check o2-04 [Drive Model (KVA) Selection].
Note:
• When you save parameter information in a keypad that you installed before you replaced the terminal block, make sure that you use that
keypad to restore the parameter data.
• To reset the performance life monitors for the components, set o4-01 to o4-13 [Maintenance Period].
To Next Page
Loading...
