YASKAWA HV600 Installation & Startup

6.6 Peripheral Devices and Options
168 YASKAWA TOEPYAIH6B01A HV600 AC Drive Narrow Bypass Installation & Startup
NOTICE: Separate the communication wiring from drive power lines, and install a noise filter to the input side of the power
supply for communication. Electrical interference can cause communication data errors.
5. Make sure that you did not pinch cables between the front cover and the bypass enclosure, then replace and
secure the front cover.
6. Set the bypass parameters for option functionality. Refer to the option manual for your communication
protocol for programming information.

YASKAWA HV600 Specifications

General

Category	DC Drives
Series	HV600
Overload Capacity	150% for 60 seconds
Output Voltage	0 - Input Voltage
Enclosure	NEMA 1, NEMA 12
Communication	Ethernet/IP, Modbus, DeviceNet, Profibus
Safety	Safe Torque Off (STO)
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short Circuit
Humidity	5-95% (non-condensing)
Altitude	Up to 1000m (3280ft) without derating
Control Method	Vector Control