4.2 Basic Wiring Diagrams
4-11
4
Wiring and Connecting SERVOPACKs
Note: 1. You can use parameters to change the functions allocated to the /DEC, P-OT, N-OT, /EXT1, /EXT2, and /
EXT3 input signals and the /SO1, /SO2, and /SO3 output signals. Refer to the following section for details.
6.1 I/O Signal Allocations on page 6-4
2. If you use a 24-V brake, install a separate power supply for the 24-VDC power supply from other power
supplies, such as the one for the I/O signals of the CN1 connector. If the power supply is shared, the I/O
signals may malfunction.
3. Default settings are given in parentheses.
To Next Page
Loading...
