4.7 Connecting MECHATROLINK Communications Cables
4-43
4
Wiring and Connecting SERVOPACKs
4.7
Connecting MECHATROLINK Communications Cables
Connect the MECHATROLINK-III Communications Cables to the CN6A and CN6B connectors.
Note: The length of the cable between stations (L1, L2, ... Ln) must be 50 m or less.
Use the following procedure to remove the MECHATROLINK-III Communications Cable con-
nectors from the SERVOPACK.
Note: The MECHATROLINK-III Communications Cable connector may be damaged if it is removed without being
unlocked.
SERVOPACK
Lock ejector
1. Slide the lock ejector
toward the SERVOPACK.
2. Remove the connector
while the lock ejector is slid
toward the SERVOPACK.
To Next Page
Loading...
