YASKAWA SGD7S-****20A Series - Page 525

13.1 List of Servo Parameters
13.1.2 List of Servo Parameters
13-38
Pn853
2
Latch Sequence 5 to 8
Settings
0000h to
3333h
– 0000h All
Immedi-
ately
Setup
*1
Pn860
2
SVCMD_IO Input Signal
Monitor Allocations 1
0000h to
1717h
– 0000h All
Immedi-
ately
Setup
*1
Continued on next page.
Continued from previous page.
Parameter
No.
Size
Name
Setting
Range
Setting
Unit
Default
Setting
Applicable
Motors
When
Enabled
Classi-
fication
Refer-
ence
n.X
Latch Sequence 5 Signal Selection
0Phase C
1 EXT1 signal
2 EXT2 signal
3 EXT3 signal
n.X
Latch Sequence 6 Signal Selection
0 to 3
The settings are the same as those for the Latch Sequence 5 Signal Selec-
tion.
n.X
Latch Sequence 7 Signal Selection
0 to 3
The settings are the same as those for the Latch Sequence 5 Signal Selec-
tion.
n.X
Latch Sequence 8 Signal Selection
0 to 3
The settings are the same as those for the Latch Sequence 5 Signal Selec-
tion.
M3
*9
n.X
Input Signal Monitor Allocation for CN1-13 (SVCMD_IO)
0 Allocate bit 24 (IO_STS1) to CN1-13 input signal monitor.
1 Allocate bit 25 (IO_STS2) to CN1-13 input signal monitor.
2 Allocate bit 26 (IO_STS3) to CN1-13 input signal monitor.
3 Allocate bit 27 (IO_STS4) to CN1-13 input signal monitor.
4 Allocate bit 28 (IO_STS5) to CN1-13 input signal monitor.
5 Allocate bit 29 (IO_STS6) to CN1-13 input signal monitor.
6 Allocate bit 30 (IO_STS7) to CN1-13 input signal monitor.
7 Allocate bit 31 (IO_STS8) to CN1-13 input signal monitor.
n.X
CN1-13 Input Signal Monitor Enable/Disable Selection
0 Disable allocation for CN1-13 input signal monitor.
1 Enable allocation for CN1-13 input signal monitor.
n.X
Input Signal Monitor Allocation for CN1-7 (SVCMD_IO)
0 to 7 The settings are the same as the CN1-13 allocations.
n.X
CN1-7 Input Signal Monitor Enable/Disable Selection
0 Disable allocation for CN1-7 input signal monitor.
1 Enable allocation for CN1-7 input signal monitor.