YASKAWA Z1000 - Page 219

Power Scale is attribute 26
Voltage Scale is attribute 27
Time Scale is attribute 28.
No. Parameter Name Setting Range Default
Z4-17 Speed Scaling
-15 to 15
0
Z4-18 Current Scaling 0
Z4-19 Torque Scaling 0
Z4-20 Power Scaling 0
Z4-21 Voltage Scaling 0
Z4-22 Time Scaling 0
n
Z4-23 to Z4-32: Dynamic Output Assembly Parameters
Parameters used in Output Assembly 116. Each parameter contains a MEMOBUS/Modbus address. The value received for
Output Assembly 116 will be written to this corresponding MEMOBUS/Modbus address. A MEMOBUS/Modbus address
value of 0 means that the value received for Output Assembly 116 will not be written to any MEMOBUS/Modbus register.
No. Parameter Name Setting Range Default
Z4-23 DOA116 1 0 to FFFFH 0
Z4-24 DOA116 2 0 to FFFFH 0
Z4-25 DOA116 3 0 to FFFFH 0
Z4-26 DOA116 4 0 to FFFFH 0
Z4-27 DOA116 5 0 to FFFFH 0
Z4-28 DOA116 6 0 to FFFFH 0
Z4-29 DOA116 7 0 to FFFFH 0
Z4-30 DOA116 8 0 to FFFFH 0
Z4-31 DOA116 9 0 to FFFFH 0
Z4-32 DOA116 10 0 to FFFFH 0
n
Z4-33 to Z4-42: Dynamic Input Assembly Parameters
Parameters used in Input Assembly 166. Each parameter contains a MEMOBUS/Modbus address. The value sent for Input
Assembly 166 will be read from this corresponding MEMOBUS/Modbus address. A MEMOBUS/ Modbus address value of
0 means that the value sent for Input Assembly 166 is not defined by the user, therefore the option default register value will
be returned.
No. Parameter Name Setting Range Default
Z4-33 DIA116 1 0 to FFFFH 0
Z4-34 DIA116 2 0 to FFFFH 0
Z4-35 DIA116 3 0 to FFFFH 0
Z4-36 DIA116 4 0 to FFFFH 0
Z4-37 DIA116 5 0 to FFFFH 0
Z4-38 DIA116 6 0 to FFFFH 0
Z4-39 DIA116 7 0 to FFFFH 0
Z4-40 DIA116 8 0 to FFFFH 0
Z4-41 DIA116 9 0 to FFFFH 0
Z4-42 DIA116 10 0 to FFFFH 0
5.15 Z: Bypass Parameters
YASKAWA ELECTRIC SIEP YAIZ1B 01E YASKAWA AC Drive – Z1000 Bypass Technical Manual
219
5
Programming