Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/T5 Series/CP860/CP920 IP Phones
346
Procedure
Call list show number can be configured using the following methods.
Central Provisioning
(Configuration File)
Configure call list show number.
Parameter:
features.call_log_show_num
Configure call list show number.
Navigate to:
http://<phoneIPAddress>/servlet?p
=features-general&q=load
Details of the Configuration Parameter:
features.call_log_show_num
Description:
Enables or disables the IP phone to show the other party’s phone number instead of the
name in the call log lists.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), the IP phone will show the other party’s name in the call log lists.
If it is set to 1 (Enabled), the IP phone will show the other party’s phone number in the call
log lists.
Note: It works only if the value of the parameter “features.save_call_history” is set to 1
(Enabled).
Web User Interface:
Features->General Information->Call List Show Number
Phone User Interface:
None
To configure call list show number via web user interface:
1. Click on Features->General Information.