the “Event: ACTION-URI” header. The phone will directly perform the specified action.
Note: It works only if the value of the parameter “features.action_uri.enable” is set to 1
(Enabled).
Web User Interface:
None
Phone User Interface:
None
Description:
Configures the IP address of the server from which the IP phone receives the action URI
requests.
For discontinuous IP addresses, multiple IP addresses are separated by commas.
For continuous IP addresses, the format likes *.*.*.* and the “*” stands for the values
0~255.
For example: 10.10.*.* stands for the IP addresses that range from 10.10.0.0 to
10.10.255.255.
If left blank, the IP phone will reject any HTTP GET request.
If it is set to “any”, the IP phone will accept and handle HTTP GET requests from any IP
address.
Example:
features.action_uri_limit_ip = 10.3.6.117, 10.3.6.119
Note: It works only if the value of the parameter “features.action_uri.enable” is set to 1
(Enabled).
Web User Interface:
Features->Remote Control->Action URI Allow IP List
Phone User Interface:
None
To configure the trusted IP address(es) for action URI via web user interface:
1. Click on Features->Remote Control.
2. Enter the IP address or any in the Action URI Allow IP List field.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
