Yealink W52P

User Guide for the W52P IP DECT Phone
4
Connecting the Base Station
You have two options for power and network connection of the base station. Your system
administrator will advise you which one to use.
 AC power
 Power over Ethernet (PoE)
Note
AC Power
To connect the AC power:
1. Connect the DC plug on the power adapter to the DC5V port on the base station and
connect the other end of the power adapter into an electrical power outlet.
2. Connect the included or a standard Ethernet cable between the Internet port on the base
station and the Internet port in your network or the switch/hub device port.
Note
Power over Ethernet
With the included or a regular Ethernet cable, the base station can be powered from a
PoE-compliant (IEEE 802.3af) switch or hub.
Please pay attention to the radio coverage of the base station. It is up to 300m in unobstructed
outdoor areas and up to 50m inside buildings.
Do not set up the base station in a damp room, and keep away from the water.
The base station should be used with Yealink original power adapter (5V/600mA) only. The use of
the third-party power adapter may cause the damage to the base station.