Yealink W52P - Call Hold;Resume; Call Waiting Feature

User Guide for the W52P IP DECT Phone
66
microphone temporarily.
To mute a call:
1. Press during an active call.
The call is muted, and the icon is displayed on the LCD screen.
To un-mute a call:
1. Press again.
The icon disappears from the LCD screen.
Call Hold/Resume
You can place an active external call on hold. At any time, at most one active call can be in
progress on your handset. You can answer or make another call while placing the original call on
hold.
To place a call on hold:
1. Press the Options soft key during a call, and then select Hold.
The call is placed on hold, and the icon is displayed on the LCD screen.
To resume a hold call:
Do one of the following:
- Press the Resume soft key.
- Press .
- Press .
Two calls on Hold:
If two calls are placed on hold on the handset, press the Resume soft key to resume the current
call. Press , or the Swap soft key to swap between two calls.
Note
Call Waiting
You can enable or disable call waiting feature on the handset. If call waiting feature is enabled,
the handset will notify you of a new incoming call during a call, and present the incoming call
information visually on the LCD screen. You can also enable the handset to play a warning tone
when receiving a new incoming call during a call. If call waiting feature is disabled, the new
incoming call will be automatically rejected by the handset.
When the call on the handset is placed on hold, placing the handset in the charger cradle will not
end the call.