Yealink W52P

Phone Settings
51
3. (Optional.) Select the default outgoing line from the Default field. The default outgoing line
is the first line you selected. You can only select the line number you have checked for the
handset, or it will not take effect.
4. Click Confirm to save the change.
As the configuration shown above, you can do the following:
- For Handset1: Line 3 (1045) is assigned to Handset1, and it is the default outgoing line. You
can only place a call using line 3 (1045).
- For Handset2: Line 1 (1023) and line 3 (1045) are assigned to Handset2, and the default
outgoing line is line1. You can place a call using line 1 (1023) or line 3 (1045).
- For Handset3: Line 2 (104) is assigned to Handset3, and it is the default outgoing line. You
can only place a call using line 2 (104).
- Both Handset 1 and Handset 2 can place a call using the line 3 (1045) at the same time.
To change the default outgoing line via the handset:
1. Press to enter the main menu.
2. Select Settings->Telephony->Default Line.
The LCD screen displays all outgoing lines currently assigned to the handset. The default
outgoing line is highlighted and followed by a left arrow.
3. Press or to highlight the desired line, and then press the OK soft key.
The default outgoing line is changed successfully.
Incoming Lines
After the handset is registered to the base station (refer to Handset Registration), you can assign
one or more incoming lines for the handset. The handset can only receive incoming calls of the
assigned incoming line(s). You can assign incoming lines to all handsets registered to the same
base station on your handset.