User Guide for the W52P IP DECT Phone
56
3. Press or to highlight the desired configuration type.
4. Press the Change soft key.
The radio box of the selected configuration type is marked.
For more information on placing an internal call, refer to Placing Internal Calls on page 62.
Base Restart
In some instances, you may need to restart the base station to refresh the settings.
To restart the base station via the handset:
1. Press to enter the main menu.
2. Select Settings->System Settings->Base Restart.
3. Enter the system PIN (default: 0000), and then press the Done soft key.
After the above steps, the registration LED and network status LED go out simultaneously. After
a period of time, the LED indicators will illuminate solid green again when the base station
restarts successfully.
Base restart is also configurable via the web user interface at the path: Settings->Upgrade.
Base PIN
To avoid unauthorized register or access to some features on the handset, you should keep the
base PIN secret. The default base PIN is “0000”, you can change the default base PIN.
To change the base PIN via the handset:
1. Press to enter the main menu.
2. Select Settings->System Settings->Change Base PIN.
3. Enter the system PIN (default: 0000), and then press the Done soft key.
4. Enter the new PIN in the Enter New PIN and Re-enter New PIN field respectively.
5. Press the Save soft key to accept the change.
Base PIN is also configurable via the web user interface at the path: Security->Base PIN.
Note
Base Reset
You can reset the base station to factory settings. This will clear all individual settings of the base
station (e.g., directory and account registrations). Handset registrations and the system PIN will
not be reset to factory defaults. We recommend that you ask your system administrator for
advice before resetting your base station.
We recommend you to set the new PIN in random and cannot be easily guessed.
To Next Page
Loading...
