Yealink W52P

User Guide for the W52P IP DECT Phone
70
4. Press the Options soft key, and then select Call Transfer.
The LCD screen displays the target party (user B) you will transfer the call to.
5. Press the Transfer soft key to complete the transfer.
The handset returns to the idle screen. Call is established between user A and User B.
Note
Conference Call
You can create a conference with other two external parties using the phone’s local conference.
The W52P IP DECT phone also supports network conference.
Note
Local Conference
You can use the handset to create a local conference with other parties. The handset supports
up to 3 parties (including yourself) in a conference call. You can create a conference between an
active call and a held call on the handset (on the same line or different lines).
To set up a local conference call with two external parties via the handset:
1. Place a call to the first party.
2. Press the Options soft key, and then select Conference.
3. Do one of the following:
- Enter the number of the second party or select the handset you want to add to the
conference.
Press , , or the Conf. soft key to dial out.
- Press the Directory soft key, and then select the desired contact.
Press , , or the Call soft key.
If both the office number and the mobile number of the contact are stored, select the
desired number and then press , , or the OK soft key to dial out.
4. When the second party answers the call, you can consult with him or her before adding the
call to the conference.
5. Press the Conf. soft key again to join the two calls in the conference.
To join two calls in a conference via the handset:
1. Place two calls on the handset.
2. Select the desired call and make sure the call is active.
Network conference is not available on all servers. For more information, contact your system
administrator.
The internal incoming call cannot be transferred.