Yealink W52P

Call Features
83
 26 to 30: You can broadcast audio to a specific channel. We recommend that you specify
these channels when broadcasting with Yealink IP phones running new firmware version
(new paging mechanism).
The IP phones will automatically ignore all incoming multicast paging calls on the different
channel.
Note
Sending RTP Stream
To configure paging list via web user interface:
1. Click on Directory->Multicast IP.
2. Enter the multicast IP address(es) and port number (e.g., 224.5.6.20:10008) in the Paging
Address field.
3. Enter the string that will appear on the LCD screen in the Label field.
4. Select the desired channel from the pull down list of Channel.
5. Click Confirm to accept the change.
To configure a default codec for multicast paging via web user interface:
1. Click on Features->General Information.
2. Select the desired codec from the pull-down list of Multicast Codec.
The IP phones on different network segment cannot send/receive RTP stream to/from
pre-configured multicast address(es) and channel(s).