Yealink W52P

User Guide for the W52P IP DECT Phone
58
3. Enter the system PIN (default: 0000) and then press the Done soft key.
4. Enter the valid value in the Username field and then press the OK soft key.
5. Enter the valid value in the Password field and then press the OK soft key.
The LCD screen prompts “Update now?”.
6. Press the Yes soft key to perform an update or the No soft key to cancel.
Eco Mode+
Eco mode+ turns off the transmission power and the radio waves emitted are virtually
zero when the phone is in the standby mode. If the eco mode+ is enabled, and there is
no signal interaction between the handset and the base station, the color of the signal
strength indicator on the idle screen will display in green. When a call comes in or a
connection occurs, the phone exits the eco mode+ automatically, and the signal
strength indicator on the idle screen changes from green to white.
To configure eco mode+ via the handset:
1. Press to enter the main menu.
2. Select Settings->System Settings->Eco Mode+.
3. Press the Change soft key.
4. Enter the system PIN (default: 0000) and then press the Done soft key.
The LCD screen prompts “Setting takes effect after base reboot. Reboot now or not?”.
5. Press the Yes soft key to reboot the base station.
The base station reboots to make the configuration take effect. The configuration applies to
all the handsets registered to the base station. The color of the signal strength indicator on
the idle screen will change from white to green.
Eco Mode
Eco mode greatly reduces the transmission power and signal output when the phone is
in the talk mode. The attenuation range is 20m. When the distance between the base
station and the handset is over 20m, the eco mode is disabled automatically.
To configure eco mode via the handset:
1. Press to enter the main menu.
2. Select Settings->System Settings->Eco Mode.
3. Press the Change soft key to check or uncheck the Eco Mode checkbox.
If the Eco Mode checkbox is checked, the eco mode is enabled.
Note
If the eco mode is enabled, the coverage area of the base station will be reduced.