User Guide for the W52P IP DECT Phone
84
The default codec is G722.
3. Click Confirm to accept the change.
Note
Receiving RTP Stream
You can configure the phone to receive a Real Time Transport Protocol (RTP) stream from the
pre-configured multicast address(es) and channel(s) without involving SIP signaling. You can
specify up to 31 multicast addresses and channels that the phone listens to on the network.
Note
How the phone handles incoming multicast paging calls depends on Paging Barge and Paging
Priority Active parameters are configured via web user interface.
Default codec for multicast paging is configurable via web user interface only.
RTP stream is listened in the speakerphone mode by default. If you want to listen the RTP stream
using the engaged audio device (earpiece, earphone or speakerphone), contact your system
administrator for more information.
Fixed volume to play RTP stream for specified paging group is configurable by your system
administrator.
To Next Page
Loading...
