Yealink W52P

Phone Settings
59
Repeater Mode
Repeater mode extends the radio coverage of the base station. The repeater has the same radio
coverage as the base station. This feature is especially useful for users who require mobility in
large dwellings. If the repeater mode is enabled, and a repeater is registered to the base station,
the handset registered to the base station can be used either in the base station or the repeater
coverage area, thereby providing users with greater freedom in mobility.
To configure the repeater mode via the handset:
1. Press to enter the main menu.
2. Select Settings->System Settings->Repeater Mode.
3. Press the Change soft key to check the Repeater Mode checkbox.
The LCD screen prompts “Setting takes effect after base reboot. Reboot now or not?”.
4. Press the Yes soft key to reboot the base station.
5. The base station reboots to make the configuration take effect. The configuration applies to
all the handsets registered to the same base station.
Note
Repeater mode and eco mode+ cancel each other out. These two features cannot be used at the
same time.
For more information on how to use DECT repeater with the base station, refer to Yealink DECT
Repeater RT10 User Guide, Yealink DECT Repeater RT20 User Guide and Yealink DECT Repeater
RT20U User Guide .