Yealink W52P - Page 46

User Guide for the W52P IP DECT Phone
34
and time from the Simple Network Time Protocol (SNTP) server by default. If your handset
cannot obtain the date and time from the SNTP server, you need to configure the date and time
manually.
To configure date and time manually for all handsets via web user interface.
1. Click on Settings->Time & Date.
2. Select Enabled from the pull-down list of Manual Time.
3. Enter the time and date in the corresponding fields.
4. Click Confirm to accept the change.
To configure date and time manually for a specific handset:
1. Press to enter the main menu.
2. Select Settings->Date & Time.
3. Edit the desired value in the Date and Time field respectively.
4. Press the Save soft key to accept the change.
The date and time displayed on the LCD screen will change accordingly.
Note
You can configure the time format and date format respectively. The handset supports two time
formats (12 Hour or 24 Hour) and seven date formats. The available date formats are listed in
the following table:
Date Format
Example (2016-12-02)
WWW MMM DD
Fri. Dec 02
DD-MMM-YY
02-Dec-16
YYYY-MM-DD
2016-12-02
DD/MM/YYYY
02/12/2016
MM/DD/YY
12/02/16
Before you configure date and time manually for a specific handset, you should enable the
Manual Time via web user interface first, or it would not take effect.