Yealink W52P

User Guide for the W52P IP DECT Phone
76
To configure the voice mail tone via web user interface:
1. Click on Features->General Information.
2. Select the desired value from the pull-down list of Voice Mail Tone.
3. Click Confirm to accept the change.
Note
To leave a voice mail:
You can leave a voice mail to someone else when he or she is busy or inconvenient to answer
the call. Follow the voice prompts from the system server to leave a voice mail, and then hang
up.
To configure the voice mail access code via the handset:
1. Press to enter the main menu.
2. Select Voice Mail->Set Voice Mail.
3. (Optional.) Press or to highlight the desired line, and then press the Select soft
key.
4. Press or to select Enabled from the Status field.
5. Enter the voice mail access code in the Number field (e.g., *4).
6. Press the OK soft key to accept the change or the Back soft key to cancel.
Note
To configure fast access for voice mail via the handset:
You can configure fast access to the voice mails of the desired line by long pressing the digit key
Voice mail access codes must be predefined on the system server. Contact your system
administrator for the more information.
Voice mail tone is configurable via web user interface only.