Yeastar Technology MyPBX Standard Administrator's Guide

MyPBX Standard Administrator Guide
6
Placement Instructions
To avoid unexpected accident, personal injury or device damage, please read the
following instructions before installing MyPBX.
Connecting MyPBX Standard
Connection of Ethernet Ports
MyPBX Standard provides two10/100M adaptive RJ45 Ethernet ports, LAN and WAN.
Connect one end of a network cable to the LAN/WAN port of the MyPBX Standard,
and the other end to any port of company’s switch/router.
Connection of FXO/FXS/BRI/GSM/UMTS/CDMA Ports
MyPBX Standard supports various outside lines, FXO, FXS,BRI and
GSM/UMTS/CDMA.
 Connection of FXO ports
The FXO port could be connected to the PSTN line or the FXS port of a traditional
PBX with aphone line.
 Connection of FXS ports
Connect one end of a RJ11 phone cable to the port, connect the other end to the
analog phone.
 Connection of BRI ports
 Ambient Temperature: to avoid overheating, please do not run MyPBX
Standard in the place where the ambient temperature is above 104°F
(40°C ).
 Ventilation: please make sure that the device has good ventilation
around.
 Anti-jamming: there may be some sources of interference that might
affect the normal running of the Gateway. It’s highly recommended that
the device
i. Should be placed away from high-power radio, radar
transmitters and high frequency, and high-current devices.
ii. Is using independent power junction box and effective anti-grid
interference measures have been taken.
 Mechanical load: Please make sure that the device is placed steadily
to avoid any accident that might cause damage. If placed on the
desktop, please ensure it is horizontally placed.

Yeastar Technology MyPBX Standard Specifications

General

Brand	Yeastar Technology
Model	MyPBX Standard
Category	PBX
Language	English