Yeastar Technology MyPBX Standard Administrator's Guide

MyPBX Standard Administrator Guide
89
Type.
Step2: Enter the IP Address.
Step3: Enter the Subnet Mask.
Step4: Enter the Gateway Address.
Step5: Enter the Primary DNS and Secondary DNS.
Step6:Save the changes.
Step7: Reboot the device.
Step8: Check the WAN Status (Status  Network status).
PPPOE
If your DSL provider saysthat you are connectingthrough
PPPoE or if younormally enter a user nameand password
to access theInternet, perform thesesteps:
Step1: Select“PPPoE” as theWAN Connection Type.
Step2: Enter the User Name.
Step3: Enter the Password.
Step4:Save the changes.
Step5: Reboot the device.
Step6: Check the WAN Status (Status  Network status)
DHCP Server
Dynamic Host Configuration Protocol (DHCP) is a network protocol that enables a
server to automatically assign an IP address to a computer from a defined range of
numbers (i.e., a scope) configured for a given network. You can set a local network
NTP server for MyPBX here, too.
Note: MyPBX Standard can work as a DHCP server, but cannot act as a router.
Figure 18-3 DHCP Server
VLAN Settings
VLAN (Virtual Local Area Network) is a group of hosts with a common set
ofrequirements, which communicate as if they were attached to the samebroadcast
domain, regardless of their physical location.

Yeastar Technology MyPBX Standard Specifications

General

Brand	Yeastar Technology
Model	MyPBX Standard
Category	PBX
Language	English