MyPBX Standard Administrator Guide
77
PBX Basic Settings
This chapter explains PBX basic settings, which can be applied globally to MyPBX
Standard. The basic settings can be configured under PBX→Basic Settings.
General Preferences
Business Hours
General Preferences
1) General Settings
Table 16-1 General Preferences-General
The absolute maximum amount of time permitted for a call. A
setting of 0 disables the timeout. The default value is 6000s.
Maximum concurrent calls limits. The default value 0 means no
limit.
Used to set hold music for the system.
Select country to set the default tones (dial tone, busy tone, ring
tone etc.) to be sent from FXS port.
The default setting is United States/North America.
Enable Dsp to optimize Fax reception.
Select country to set the On Hook Speed, Ringer Impedance,
Ringer Threshold, Current Limiting, TIP/RING voltage
adjustment, Minimum Operational Loop Current, and AC
Impedance as predefined for your country's analog line
characteristics.
The default setting is FCC for USA.
Attended Transfer
Caller ID
When transferring an incoming call using the attended transfer
feature code or the transfer key of IP phone, the Caller ID of
transferee or transferer displayed on the screen of the callee.
The default display is the Caller ID of the initiator.
If “Enable Follow Me Prompt” choosing “Yes”, there will be
prompt before transferring the call. Otherwise, the call will be
transferred directly without any prompt. Default: Yes.
Music on hold for
Follow Me
The user could choose to play default music-on-hold, ringing
tone or stay mute when forwarding the call.
Invalid Phone Number
Prompt
Configure the prompt when the dialed phone number is invalid.
Configure the prompt when the dialed phone number is busy.
Configure the prompt when dial failed due to conjunction
To Next Page
Loading...
Need help?
General
