Yeastar Technology MyPBX Standard Administrator's Guide

MyPBX Standard Administrator Guide
10
Insert FXS module on MyPBX and connect analog phones to FXS ports. Connect
analog phones to FXS ports on MyPBX Standard, users could make calls between
extensions just by dialing the other’s extension number.
If IP terminals have registered to MyPBX Standard successfully, users could also
make internal calls using SIP extensions.
 Outbound calls
Firstly, please connect PSTN/BRI lines to FXS/BRI ports on MyPBX Standard. To
extend GSM/UMTS/CDMA trunk, you need to insert the relevant modules to
MyPBX and insert SIM card to the module.
Then the default extensions are able to make outbound calls via the trunks by
simply dialing “9+phone number”.
Note:the dial pattern of the default outbound route is “9.” and strip 1 digit. If you
have changed it, please dial according to the outbound route settings.
 Inbound calls
When the user calls the trunk number of the PSTN, BRI or GSM trunk, MyPBX
Standard would route the call to IVR (the “welcome” prompt) by default. Then the
user can operate following the prompt.

Yeastar Technology MyPBX Standard Specifications

General

Brand	Yeastar Technology
Model	MyPBX Standard
Category	PBX
Language	English