App-23
IM DL850E-03EN
Appendix
App
Operation Key
Soft Key Setting
Invert OFF
Linear Scale OFF
CH1 to 16 (16CH VOLT (720220))
V/div 2.000 V/div
Position 0.00 div
Label Channel number
Coupling DC
BandWidth Full
V Scale DIV
V Zoom ×1
Offset 0 mV
Invert OFF
Linear Scale OFF
CH1 to 16 (16CH TEMP/VOLT (720221))
V/div 2.000 V/div
Position 0.00 div
Data Update Period 100 ms
Label Channel number
Coupling DC
V Scale DIV
V Zoom ×1
Offset 0.0 mV
Invert OFF
Linear Scale OFF
CH1 to 16 (LOGIC (720230))
Position 0.00 div
Label Channel number
Bit Mapping Auto
CH13 to 16 (CAN MONITOR (720240))
All SubChannels Setup
Input OFF
Label Channel number
Message Format STD
ID (Hex) 0
Byte Count Auto
Start Bit 0
Bit Count 8
Byte Order Big
Value Type Unsigned
Factor 1
Offset 0
Port Setup
Bit Rate 500 Kbps
Sample Point 85%
Sync Jump Width 2
Bit Sample Num 1
Listen Only OFF
Terminator OFF
Scale Auto
One Shot Out
Message Format STD
ID (Hex) 000
Frame Data
DLC 0
Data (Hex) 00 00 00 00
00 00 00 00
CH13 to 16 (CAN & LIN (720241))
The values for CAN are the same as the
values for the 720240.
All SubChannels Setup
Input OFF
Label Channel number
Operation Key
Soft Key Setting
ID (Hex) 0
Start Bit 0
Bit Count 8
Byte Order Little
Value Type Unsigned
Factor 1
Offset 0
Port Setup
Bit Rate 19200 bps
Frame Setup
Data Length 1
Check Sum Classic
Scale Auto
CH9 to 16 (SENT (720243))
SENT Format Setup
Clock Tick 3.00 µs
Data Nibbles Number 6
Pause Pulse ON
CRC Type Recommended
Slow CH Type Enhanced (ID 8 bit
+ Data 12 bit)
Error Channel Setup
Fast Channel CRC
Detect ─
Error Trigger ON
Error Count ON
Slow Channel CRC
Detect ─
Error Trigger ON
Error Count ON
Nibble Value
Detect ─
Error Trigger ON
Error Count ON
Successive Calibration Pulses (Option2)
Detect OFF
Error Trigger ON
Error Count ON
Pulse Number
Detect ─
Error Trigger ON
Error Count ON
Error Count Reset on Start
ON
Probe Setup
Probe 1:1
All SubChannels Setup
Sub channel number Data Type Input Label
1 FastCH ON CH<x>_F1
2 FastCH ON CH<x>_F2
3 FastCH ON CH<x>_F3
4 S&C ON CH<x>_SC
5 SlowCH ON CH<x>_S1
6 SlowCH ON CH<x>_S2
7 SlowCH ON CH<x>_S3
8 SlowCH ON CH<x>_S4
9 SlowCH ON CH<x>_S5
10 Error Trigger ON CH<x>_ET
11 Error Count ON CH<x>_EC
Appendix 4 Default Values