Zebra 105SL Plus User Manual

177
Index
7/3/13 P1056468-002
reset network settings
user menu item, 35
ways to reset, 99
reset printer to default values, 93
restore
factory default settings, 19
network settings, 19
printer or printer default values, 93
rewind spindle, 113
ribbon
adhesive test, 50
broken or melted ribbon, 146
determining coated side, 49
removal, 112
ribbon not detected correctly, 146
scratch test, 50
setting print method to Thermal Transfer mode, 85
specifications, 165
when to use, 49
wrinkled ribbon, 146
ribbon sensor
cleaning, 128
location, 128
when to clean, 125
ribbon sensor calibration
procedure, 106
user menu item, 27
ways to initiate, 94
roll media, 47
loading, 61
routine maintenance, 123
run a ZBI program
START PROGRAM user menu item, 32
ways to run, 95
S
schedule for cleaning, 125
scratch test
media type, 49
ribbon coated side, 50
self tests, 148
CANCEL, 149
communications diagnostics, 155
FEED, 151
FEED and PAUSE, 154
PAUSE, 150
Power-On Self Test (POST), 148
sensor profile
how to print, 91
user menu item, 26
sensor type
user menu item, 22
ways to select, 102
sensors
cleaning, 128
interpreting sensor profile, 156
label-available sensor location, 128
lower media sensor adjustment, 118
ribbon sensor location, 128
transmissive (media) sensor adjustment, 115
serial communications
user menu item, 27
ways to set, 103
serial port
characteristics of serial connection, 41
setup, 37
unpack the printer, 38
shipping
report damage, 38
reshipping the printer, 38
SHORT CAL
how to set as power-up action, 92
how to set for head-close action, 92
initiating through control panel, 16
site selection for printer, 39
smudge marks on labels, 137
snap plate
cleaning, 130
when to clean, 125
spacing requirements, 39
specification
print, 163
specifications
electrical, 162
environmental, 162
physical, 162
power cord, 44
ribbon, 165
standard features, 160
storing the printer, 38
subnet mask
user menu item, 34
ways to view or set, 98
surface for printer, 39
T
tag stock, 47
Tear-Off mode
description and media path, 51
how to select, 84
select print mode through user menu, 21
tear-off bar cleaning, 125

Zebra 105SL Plus Specifications

General

Weight	50 lbs / 22.7 kg
Humidity	20-85% non-condensing
Print Method	Thermal Transfer
Resolution	203 dpi (8 dots/mm)
Max Print Width	4.09 inches / 104 mm
Max Print Speed	12 inches per second / 305 mm per second
Memory	16 MB SDRAM, 8 MB Flash
Media Width	0.79 inches / 20 mm to 4.5 inches / 114 mm
Media Thickness	0.003 inches / 0.076 mm to 0.012 inches / 0.305 mm
Media Types	Continuous, die-cut, black mark
Ribbon Width	2.00 inches / 51 mm to 4.33 inches / 110 mm
Ribbon Length	1476'/450 m
Connectivity	Parallel, Serial
Optional Connectivity	Ethernet, Wireless
Power Requirements	90-264 VAC; 48-62 Hz
Operating Temperature	40°F to 105°F / 5°C to 40°C
Storage Temperature	-40°F to 140°F / -40°C to 60°C