Zebra CC600 Product Reference Guide

Getting Started
25
Resetting the Device
The device has a recessed reset button (see CC6000 Back View on page 13 and CC600 Back View on
page 16 for the location of the button).
To activate the reset button, use the tip of a small paper clip (1mm in diameter), insert into the recess, push
and hold for 3 seconds.
Device has a recovery console accessible via pressing the Button #1 on the back of the device upon power
up or via ADB connection and command.
The following reset functions are supported:
• Soft reset is performed with an ADB command.
• Enterprise reset (see Performing an Enterprise Reset on page 111 for more information).
• Factory reset (see Performing a Factory Reset on page 112 for more information).
The device recovery mode supports the following functions:
• Flash image from zip file on an SD card or from internal flash.
• Apply a system update from an SD card or from internal flash.

Zebra CC600 Specifications

General

Brand	Zebra
Model	CC600
Category	Touchscreen
Language	English