Applications
56
Enabling PTT Communication
1. Swipe up from the bottom of the Home screen and touch .
2. Slide the Enable/Disable Switch to the ON position. The button changes to ON.
Selecting a Talk Group
One of 32 Talk Groups can be selected by PTT Express users. However, only one talk group may be
enabled at a time on the device. Touch one of the 32 Talk Groups. The selected Talk Group is highlighted.
PTT Communication
NOTE: This section describes the default PTT Express client configuration. Refer to the PTT Express V1.2
User Guide for detailed information on using the client.
Creating a Group Call
NOTE: When using a wired headset, use only Zebra approved wired headsets with a PTT button.
1. Press and hold the Group Call button (or the Talk button on the headset) and listen for the talk tone.
If you hear a busy tone, release the button and wait a moment before making another attempt. Ensure
that PTT Express and the WLAN are enabled.
2. Start talking after hearing the talk tone.
NOTE: Holding the button for more than 60 seconds (default) drops the call, allowing others to make Group
calls. Release the button when finished talking to allow others to make calls.
Responding with a Private Response
The Private Response can only be initiated once a Group Call has been established. The initial Private
Response is made to the originator of the Group Call.
1. After the Group Call is completed, wait until you receive an access tone.
2. Press and hold the configured PRIVATE CALL button.
3. If you hear a busy tone, release the PRIVATE CALL button and wait a moment before making another
attempt. Ensure that PTT Express and the WLAN are enabled.
The PTT Express Voice client is enabled and muted.
The PTT Express Voice client is enabled but it is not able to communicate due to a VoIP
telephony call in progress.
Table 10 PTT Express Icon Descriptions (Continued)
Status Icon Description
To Next Page
Loading...
Need help?
General
