263
Specifications
General Specifications
6/28/17 ZT510 User Guide P1095460-001
Communication
Interfaces
(continued)
Standard
(continued)
Wired Gigabit Internal Ethernet Print Server
Limitations and Requirements
• The printer must be configured to use your LAN.
• A second wired print server can be installed in the bottom
option slot.
Connections and Configuration
Refer to the ZebraNet Wired and Wireless Print Servers User
Guide for configuration instructions. A copy of this manual is
available at http://www.zebra.com/manuals.
RS-232/C Serial Data Interface
• 2400 to 115000 baud
• parity, bits/character
• 7 or 8 data bit
• XON-XOFF, RTS/CTS, or DTR/DSR handshake protocol
required
• 750mA at 5 V from pins 1 and 9
Limitations and Requirements
• You must use a null-modem cable to connect to the printer or
a null-modem adapter if using a standard modem cable.
• Maximum cable length of 50 ft (15.24 m).
• You may need to change printer parameters to match the host
computer.
Connections and Configuration
The baud rate, number of data and stop bits, the parity, and the
XON/XOFF or DTR control must match those of the host
computer.
Optional Wireless print server
See Wireless Specifications on page 267 for more information.
Limitations and Requirements
• Can print to the printer from any computer on your Wireless
Local Area Network (WLAN).
• Can communicate with the printer through the printer’s web
pages.
• The printer must be configured to use your WLAN.
• Can be installed only in the top option slot.
Configuration
Refer to the ZebraNet Wired and Wireless Print Servers User
Guide for configuration instructions. A copy of this manual is
available at http://www.zebra.com/manuals.
To Next Page
Loading...