Specifications
Power Specifications
266
P1095460-001 ZT510 User Guide 6/28/17
Power Cord Specifications
Depending on how your printer was ordered, a power cord may or may not be included. If one
is not included or if the one included is not suitable for your requirements, see Figure 24 for
specifications.
Figure 24 • Power Cord Specifications
Figure 25 • International Safety Organization Certification Symbols
Caution • For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use an
IEC 320 female connector and the appropriate region-specific, three-conductor grounded
plug configuration.
1
AC power plug for your country—This should bear the certification mark of at least one of the known
international safety organizations (Figure 25). The chassis ground (earth) must be connected to
ensure safety and reduce electromagnetic interference.
2
3-conductor HAR cable or other cable approved for your country.
3
IEC 320 connector—This should bear the certification mark of at least one of the known international
safety organizations (Figure 25).
4
Length ≤ 9.8 ft. (3 m). Rating 10 Amp, 250 VAC.
To Next Page
Loading...