89
Printer Setup and Operation
Install the Printer Driver and Connect the Printer to the Computer—Ethernet
6/28/17 ZT510 User Guide P1095460-001
4. Turn on (I) the printer.
The printer boots up.
5. Connect the printer to an Ethernet cable that is connected to your network.
The printer attempts to communicate with your network. If it is successful, it fills in your
LAN’s gateway and subnet values and gets an IP address. The printer display will
alternate between the printer’s firmware version and its IP address.
6. Check the display to see if an IP address was assigned to the printer. See WIRED IP
ADDRESS on page 141.
If the printer’s IP address is... Then...
0.0.0.0
or
000.000.000.000
Continue with Configuring the printer
with your LAN information (if necessary)
on page 90.
any other value Continue with Adding a Printer from the
Zebra Setup Utilities Screen on page 91.
To Next Page
Loading...