Printer Setup and Operation
Install the Printer Driver and Connect the Printer to the Computer—Ethernet
90
P1095460-001 ZT510 User Guide 6/28/17
Configuring the printer with your LAN information (if necessary)
If your printer connected to your network automatically, you do not need to complete this
section. Continue with Adding a Printer from the Zebra Setup Utilities Screen on page 91.
7. Connect the printer to your computer using a USB, serial, or optional parallel port as
instructed in Connect a Computer to the Printer’s USB Port on page 76 or Connect a
Computer to the Printer’s Serial or Parallel Port on page 80.
8. Configure the following printer settings. You can change the values through the Zebra
Setup Utilities (click Configure Printer Connectivity on the Zebra Setup Utilities screen)
or by the ways listed at the following links. Contact your network administrator for the
proper values for your network.
• WIRED IP PROTOCOL on page 144 (change the value from ALL to PERMANENT)
• WIRED GATEWAY on page 143 (match the gateway value of your LAN)
• WIRED SUBNET MASK on page 142 (match the subnet value of your LAN)
• WIRED IP ADDRESS on page 141 (assign a unique IP address to the printer)
To Next Page
Loading...