NOTES ON INSTRUMENT SAFETY
Cell Observer SD General Notes Carl Zeiss
M60-2-0021 e 01/2009 423638-7044-001 5
1 NOTES ON INSTRUMENT SAFETY
1.1 General Notes
The Cell Observer SD consists of the following two main components: CSU-X1 spinning disc unit and
Axio Observer.Z1. It has been designed and built to meet the requirements under DIN EN 61010-1
(IEC 61010-1) "Standard rules regarding the safety requirements for electrical equipment for
measurement, control, and laboratory use", DIN EN 60825-1 (IEC publication 60825-1) "Safety of laser
products" and DIN EN 61326-1 "Electrical equipment for measurement, control and laboratory use –
EMC requirements".
When combined with an Axio Observer.Z1, the CSU-X1 spinning disc unit complies with the require-
ments of Directive 98/79/EC (In Vitro Diagnostic Medical Device Directive). It carries the
- mark.
The Cell Observer SD must be disposed in accordance with the WEEE Directive 2002/96/EC.
The following warning and information symbols are used throughout this Manual. They will help you to
promptly understand the type and purpose of advisory or alert notes contained herein.
NOTE
This symbol indicates a note that should be closely followed.
CAUTION
This symbol indicates a possible hazard to the instrument or system.
DANGER
This symbol indicates a possible hazard to the user of the instrument.
ACHTUNG
Disconnect power supply before any kind of intervention into the system!
DANGER
Laser radiation!
DANGER
Keep the laser zone clear of flammable and combustible materials.
DANGER
Dangerous electrical voltage!
Always bear in mind: The time you invest in making yourself familiar with the equipment will
pay off many times in your work.
To Next Page
Loading...
