CARE, MAINTENANCE, TROUBLESHOOTING AND SERVICE
Carl Zeiss Care Cell Observer SD
60 423638-7044-001 M60-2-0021 e 01/2009
5 CARE, MAINTENANCE, TROUBLESHOOTING AND SERVICE
5.1 Care
Routine care which may be performed by operating personnel is limited to the following work items:
Cell Observer SD systems include no special precautions to protect from etching, potentially
infectious, toxic, radio-active or other samples that are harmful to people’s health. Where
samples of this kind are handled, all requirements, notably, national accident prevention
regulations must be properly observed in accordance with statutory law.
• Break power supply to all system units with a line supply inlet and detach the line plugs before you
proceed with work for cleaning.
Cleaning of paint-coated surfaces
• Always use a clean, slightly moistened piece of cloth. The water for cleaning may be laced with a mild
detergent.
• Do not allow liquid to penetrate into the inner system space.
• Refrain from the use of solvents.
• Use a non-shedding piece of cloth to wipe the surfaces clean and dry.
Cleaning of glass surfaces
• Use a clean optical wipe to clean glass surfaces that are soiled or covered with fingerprints.
• To remove stubborn soiling, dip the optical wipe into a mixture of distilled water and and a small
portion of detergent.
• For completion of cleaning, slightly breathe upon the glass concerned and wipe it down with a clean
piece of cloth.
• Fluff or dust should preferentially be removed with a clean natural hair brush.
5.2 Maintenance
• Perform a laser safety check each time before you make the system operational.
• For more detailed information about routine maintenance actions, you should refer to the
Axio Observer Operating Manual and the user manual of your computer system.
There are no further Cell Observer SD system maintenance actions which may be performed by
Customers. Please contact your appropriate Carl Zeiss service point for any kind of maintenance
work.
To Next Page
Loading...
