• Results:
• Throttle signal will remain at last commanded position to and clutch shifts to neutral.
• LED at Control Heads will not be lit.
• Opposite engine still under power has full control.
• Test Procedure:
• Turn power on to both Port and Starboard Processors. Take command at a Control Head.
• Move the Port and Starboard Control Head levers to approximately ½ Ahead.
• Turn power off to the Port side only.
• Port side throttle will remain at last commanded position and clutch will shift to
neutral.
• LED on the Port side of the Control Head in command will go off.
• The Port Control Head will no longer have command of the engine and gear.
• The Starboard Control Head will still have full command of the Starboard engine and
gear.
• Turn power on to the Port Processor. Take command of the Port side.
• The Port Control Head will operate as usual-(Non-volatile memory)
• Repeat test for Starboard Processor.
To Next Page
Loading...
Need help?
General
