4.4.6.2.2 Plug Termination
A Strip back 2 1/4 inches (57,15mm) of PVC jacketing.
Figure 4-23: Clutch Cable Plug Termination Connections
B Slide the boot onto the cable.
C Strip back 1/4 inch (6,35mm) from the eight conductors.
D Crimp Pins onto the eight conductors.
E Insert the pins into the appropriate terminations as shown in Table 4-6:
Clutch/Troll Termination Table.
F Slide the boot over the connector.
G Tie-wrap the boot in place.
4.4.7 Locations 10 Installation
4.4.7.1 Clutch Cable (Location 10)
A single four-conductor cable must connect the two Shift cables to the Processor through a 12 pin
plug.
4.4.7.1.1 Processor Termination
A Install a liquid tight connector into hole no.10.
B Run a 32 inch (0,82m) piece of four-conductor cable through the liquid tight
connector and tighten, leaving 16 inches (0,41m) outside of the Processor.
C Strip back 4 inches (101,6mm) of the PVC jacket inside the Processor.
Table 4-6: Clutch/Troll Termination Table
Description Conductor Color Processor Termination Plug Termination
Ahead Clutch Solenoid (+) Brown TB11-2 Pin 3
Ahead Clutch Solenoid (-) Green TB11-6 Pin 4
Astern Clutch Solenoid (+) Black TB11-1 Pin 5
Astern Clutch Solenoid (-) Yellow TB11-5 Pin 6
Troll On/Off Solenoid (+) Orange TB11-4 Pin 9
Troll On/Off Solenoid (-) White TB11-8 Pin 10
Troll Proportional Solenoid (+) Red TB11-3 Pin 11
Troll Proportional Solenoid (-) Blue TB11-7 Pin 12
To Next Page
Loading...
Need help?
General
