• The Control Head lever which was left in the Ahead detent is now inactive.
Figure 2-13: Step B) One Lever Operation Mode
2.9.2 Turning OFF One Lever Operation
A Place the Master lever into the Neutral detent.
B Place the inactive Control Head lever into the Neutral detent.
• Whenever the inactive lever is moved to the Neutral detent, One Lever operation is turned
OFF. The green LED will turn OFF, indicating that the control system is now in normal
operating mode.
NOTE: The Control Head lever designated by the operator to be inactive in One Lever Operation, may be left in
the Ahead detent or moved fully forward. Moving the lever fully forward is recommended, because it moves it
out of the way and prevents accidental bumps while operating.
WARNING: It is strongly recommended that the Master lever is returned to the Neutral/Idle position prior to
turning OFF One Lever Operation.
Do not attempt to transfer command from one Remote Station to another while in One Lever Operation.
Always turn One Lever Operation OFF prior to transferring.
Failure to observe these recommendations may result in a sudden change in the vessel’s direction.